At a glance
- Plug type
- Type A, two flat holes
- Voltage
- 100 V, held within ±6 V of 101 V
- Frequency
- 50 Hz in the east, 60 Hz in the west
- Dividing line
- The Fuji River and the Itoigawa River
On this page
- What plug type does Japan use?
- What voltage does Japan use, and will your charger work?
- Is Japan 50 Hz or 60 Hz, and where does it change?
- Do you need an adaptor or a frequency converter in Japan?
- Is Japan's electricity supply stable enough for laptops and phones?
- What goes wrong with plugs and chargers in Japan?
- FAQ
Japan's plug type is Type A, a socket with two flat holes, and the supply is 100 V everywhere. The frequency is 50 Hz in the east and 60 Hz in the west, split along the Fuji and Itoigawa rivers.
Two official pages disagree on whether visitors need a frequency converter as well as an adaptor. We read the figures below on 17 November 2026 on JNTO, GO TOKYO, Tohoku Electric Power and OCCTO pages.
What plug type does Japan use?
Japan uses Type A sockets, two flat holes side by side. JNTO's FAQ says "power outlets use Type A plugs", and GO TOKYO describes the socket as "type A, with two flat holes". A plug with two flat pins fits as it is. Any other shape, round pins or three pins, needs an adaptor.
The Japan plug type question comes down to the pins on your own plug, so look at them before you pack. Two flat, parallel pins go straight into a Japanese socket at 100 V. Round pins, angled pins or a third pin need an adaptor, and the adaptor changes only the shape, not the voltage.
The official visitor pages describe Type A and nothing else, not sockets with a third, grounding hole. Pack for two flat pins and treat anything more as a bonus.

Outlets under the seats of an E353 series train: each takes a plug with two flat pins.
What voltage does Japan use, and will your charger work?
Japan's voltage is 100 V across the country: JNTO calls it "uniformly 100 volts, A.C.", and GO TOKYO gives the same figure. OCCTO's report on fiscal 2024 says the grid operators must hold the 100 V supply within ±6 V of 101 V. That puts the outlet between 95 and 107 V.
Whether a charger works is written on the charger, in our reading of the label rather than an official page's. The input line, often printed as "100-240V", gives the voltages the device accepts. If 100 V falls inside that range, it runs on Japan's supply with only a plug adaptor. A device rated only for 220 to 240 V does not; it needs a transformer.
| Your device's label | Japan's supply | What to pack | Suits |
|---|---|---|---|
| Two flat pins, input 100-240 V | Type A, 100 V | Nothing | A charger whose plug already fits |
| Round or three pins, input 100-240 V | Type A, 100 V | A plug adaptor | A charger with a different plug |
| Input 110-120 V only | 100 V, within ±6 V of 101 V | Check the manual: 100 V is outside the stated range | Appliances with a narrow rating |
| Input 220-240 V only | 100 V | A transformer as well as an adaptor | Hair dryers and kettles; often easier left at home |
Japan's column comes from JNTO, GO TOKYO and OCCTO; the other columns are our reading of a device label.
Is Japan 50 Hz or 60 Hz, and where does it change?
Japan runs on two frequencies: 50 Hz in the east and 60 Hz in the west. Tohoku Electric Power puts the line along the Fuji River in Shizuoka and the Itoigawa River in Niigata. JNTO's plugs page names Nagoya, Kyoto and Osaka as cities in the 60 Hz west.
| Grid area (OCCTO) | Frequency | Control target | Where a visitor meets it |
|---|---|---|---|
| Hokkaido | 50 Hz | ±0.3 Hz | Hokkaido |
| Tohoku | 50 Hz | ±0.2 Hz | Tohoku, and most of Niigata |
| Tokyo | 50 Hz | ±0.2 Hz | Tokyo |
| Chubu, Hokuriku, Kansai, Chugoku | 60 Hz | ±0.2 Hz | Nagoya, and Kansai |
| Shikoku | 60 Hz | ±0.2 Hz | Shikoku |
| Kyushu | 60 Hz | ±0.2 Hz | Kyushu |
| Okinawa | 60 Hz | ±0.3 Hz | Okinawa |
The line has exceptions in Niigata: parts of Myoko and Itoigawa cities, and all of Sado city, are on 60 Hz, Tohoku Electric says. No official page we read says which appliances are affected by the change of frequency. A trip from Tokyo to Kyoto on the Shinkansen crosses the line without the outlets changing shape or voltage.
Do you need an adaptor or a frequency converter in Japan?
The two official visitor pages disagree. JNTO's FAQ says "you may need a plug adapter" and stops there. GO TOKYO says "using foreign electric appliances will require a frequency converter and plug adaptor". Neither page says when a frequency converter is needed, and JNTO's plugs page mentions conversion plugs and transformers, not converters.
Ours: pack a plug adaptor if your pins are not two flat ones, and check the voltage label as above. Buy a frequency converter only if your device's own manual asks for one. The official pages give no case in which a phone or laptop charger needs it.
Is Japan's electricity supply stable enough for laptops and phones?
Japan's 100 V supply stayed inside its standard at every measured point in fiscal 2024, OCCTO's report says: 6,686 points measured and 0 deviations. The four years before were the same, with 6,562, 6,589, 6,578 and 6,681 points measured in fiscal 2020 to 2023 and none outside the standard.
The frequency is held as tightly. OCCTO's control target is ±0.2 Hz in most areas and ±0.3 Hz in Hokkaido and Okinawa. A visitor's chargers meet a supply with little variation, so the label, not the grid, decides whether a device works.
What goes wrong with plugs and chargers in Japan?
Most charging problems in Japan come from the plug shape or the device's rating, not from Japan's grid. The sockets take two flat pins, the supply is 100 V, and OCCTO recorded 0 voltage deviations in fiscal 2024. A few habits avoid the rest.
- Round or three-pin plugs. Japan's Type A socket takes two flat pins only, so bring an adaptor.
- A 230 V hair dryer. A device rated only for 220 to 240 V needs a transformer at 100 V.
- Trusting one page on converters. GO TOKYO asks for a frequency converter; JNTO asks only for an adaptor.
- One adaptor for many devices. A phone, a camera and a pocket Wi-Fi from our eSIM and SIM cards guide all want a socket overnight.
Skip a voltage converter if every charger you pack reads 100-240 V: an adaptor is all it needs, and only if the pins are not flat. Then sort out money in Japanese yen and cash and cards in Japan.
